Which wiring is included in the harness?

The harnesses include all  the PTFE (Heluflon) low voltage wiring between the controller board and the steppers/toolhead/extruder which needs to be heat resistant and be fed through drag chains. High-voltage wiring (e.g. to the heated bed or from the mains power inlet to the power supplies) or general power wiring is included as wiring DIY pack, which provides you all necessary components to build the auxiliary harness (not included in the Linneo Lite harnesses). Also if the existing wires stepper motors come with wire which can be used (because it doesn’t need to be PTFE) this is not included (e.g. the z stepper wiring for the Voron 2.4)

Leave a Reply

Your email address will not be published.

Shopping Cart
Scroll to Top