We are here to help, any questions, issues or suggestions, just contact us and we will try to get back to you as quickly as possible.
Which wiring is included in the harness?
The harnesses include all the FEP (Linneoflon and/or Heluflon) low voltage wiring between the controller board and the steppers/toolhead/extruder which needs to be heat resistant and be fed through drag chains. High-voltage wiring (e.g. to the heated bed or from the mains power inlet to the power supplies) or general power wiring is included as wiring DIY pack, which provides you all necessary components to build the auxiliary harness (not included in the Linneo Lite harnesses). Also if the existing wires stepper motors come with wire which can be used (because it doesn't need to be FEP/PTFE) this is not included (e.g. the z stepper wiring for the Voron 2.4)
Contact us via the chat (see chat bubble on the lower right of your screen) or open a new support ticket:
Check and reply to your existing Support Tickets (you need to be logged in)
