Bigtreetech Manta M8P (V1.1)
The Bigtreetech Manta M8P (V1.1) is an Innovative and Easier Way to Run Klipper.
The controller board is born for running Klipper, it allows a direct installation of a BIGTREETECH CB1/Raspberry Pi CM4 to run Linux and Klipper.
The Manta M8P supports:
- 8x Stepper drivers
- 8x FAN
- 6x End Stop
- 4x Thermistors
- RGB1 & RGB2 for LEDs
- 3x USB 2.0
- USB Type-C
- USB-OTG/UART-to-USB
- LAN
- Inductive Probe
- SPI
- 40pin GPIO
- EXP1&EXP2 for display
- CAN bus
- HDMI*
- TFT35 SPI*
- CSD/DSI port for cameras or displays **
Please add CB1, CB2 and TMC2209 steppers if needed!
Manta M8P
✅ 32-bit 64MHz ARM® Cortex-M0+ STM32G0B1VET6 chip
✅ Designed with the same connector as the Raspberry Pi CM4, making it pin compatible with all versions of the CM4 and the CB1/CB2.
✅ It has rich expansion ports, can support various expansion modules, such as BL Touch, LCD screen, RGB light, auto shutdown, etc.
✅ TPS5450-5A Power Chip The 5A output perfectly matches the power supply need of a Raspberry Pi.
✅ Selectable CNC fan voltage, 5V/12V/24V.
✅ Added eFuse circuit protection. It will faster disconnected on overload, and automatically reset if the overload is gone, which will greatly reduce the motherboard burnout caused by short circuits.
✅ Reserved Can Bus port can be connected with EBB CAN, which will simplify the wiring and provide strong anti-interference ability.
✅ The M8P & CB1/CB2 can be the best choice for Voron 2.4, VzBot, etc.
