Linneo Umbilical CAN harness

Pre-made FEP CAN harness consisting out of twisted CAN-H & CAN-L wires plus two wires for 24V supply made from IGUS wire covered in protective sleeve for umbilical use. A second FEP wire based harness will connect the umbilical harness to the controller board under the deck. The interconnection is done by a CNLinko connector pair.

Variants:

• Molex connector (for BTT EBB36 & EBB42 (not V1.1 with white Molex connector, only V1.0 with black Molex connector)), Huvud (needs re-pinning of the Molex connector in a different order, get the Linneo pin tool if you need a Molex un-pin tool or let me know, Linneo can produce the Huvud variant on demand)
• XT30 connector (for Fysetc SB2040, BTT EBB SB2209 and EBB SB2240)

For maximum flexibility the harness has on the controller board side two fork connectors for 24V & GND and two ferrule connectors for CAN-H & CAN-L.

Comes fasteners for the CNLinko connector. A mount for the harness can be printed using this file: umbilical_mount.

Pin out:

• Green: CAN H
• Yellow: CAN L
• Black/red: 24V
• Black/black: GND

Lenghth of the harness: ~0.8m (fits for Voron 250mm up to 350mm build size)