Linneo Clicky-Clacky NanoNest Door Panel (V2.4, PC)
The original NanoNest panel from Linneo, made from PC, not acrylic, so they won’t bend.
The fitting Linneo NanoNest door panel for the the Voron 2.4 Clicky-Clacky Door Kit, made from polycarbonate (PC).
Available in 300mm and 350mm.
What is NanoNest?
NanoNest is a dual panel setup with a clear divider frame in-between. Each layer is produced from 2mm UV PC, making 6mm of total thickness.
With the frame layer in between the two external panels the thermal and noise insulation of the printer can be greatly improved.
How to install?
The three layers should be introduced in the Clicky-Clacky frame at once. The panel retainer profile is not longer needed.
Gavin Hanson (verified owner) –
These look so much cleaner than the single panel variants, not having to use the rubber gasket material makes it look very clean.
My only gripe is that the 3 panels dont fit tightly in the slot (at least on the fysetc extrusions) and therefore they can rattle quite a bit, i remedied this by adding black electrical tape around the outside edges, it makes the fit much more snug and the panels no longer rattle at any frequency.